TEC-HRO lift 3.0, fore-end / handlebar

Advantages and innovations of the TEC-HRO lift 3.0

TEC-HRO lift 3.0 was developed especially for the Kniendschießen. Through a higher-forearm, many shooters do easier in this attack. In addition this fore-end can be tilted and tilted, so that the wrist must be snapped off not so much.

Now have these possibilities but also many Liegendschützen discovered for themselves and use "lift 3.0" also for the numb. Caution: Because the numb can cause very high forces on the belt drive, all screws should be with 5 nm torque wrench and high-quality Hex keys (a 3 and a 4 is required) be tightened. 

Stehendschützen, place the rifle on the Palm of the hand or between your thumb and index finger, also benefit from this forend raiser block, because she has a nice rounded shape. 

• compact design this only 15 mm high 

• variable height adjustable by 15 - 40 mm 

• swivelled to the side

• longitudinal swiveling

• with UIT rail for attachment of hand stop...

• Weight: 283 g

• Length: 195mm

• fits all rifle stocks with "UIT rail" (Anschütz, Walther, Feinwerkbau, TEC-HRO, MEC,...)

Attention: From 2017 the fore-end with air gun shall be 120 mm high from running Center instead of only 90 mm! Thus an alternative for the air rifle is "TEC-HRO lift 3.0" for many shooters!

Attractive high-quality, German quality manufacturing - design - very stable lightweight construction